NC machine tools shall have operating procedures

Operating procedures is an important measure to ensure the safe operation of CNC machine tools. The operator must operate according to the operating procedures. When a machine tool fails, the operator should pay attention to the retention site and truthfully explain the situation before and after the failure to the maintenance personnel, so as to facilitate the analysis and diagnosis of the cause of the failure, eliminate the failure in time and reduce the downtime.

CNC machine tools should not be sealed for a long time

After the purchase of CNC machine tools to make full use of, as far as possible to improve the utilization of machine tools, especially in the first year of use, but also to make full use of, so that it is prone to failure of the weak links as soon as possible exposed, the hidden dangers of failure as far as possible in the warranty period to be excluded. With CNC machine tools reluctant to use, this is not the care of the equipment, but will accelerate the deterioration or damage of electronic components due to moisture and other reasons. If the factory has no production task and the numerical control machine tool is not used for a long time, it should also be powered on regularly and cannot be sealed for a long time. It is best to power on 1-2 times a week and run for about 1 hour each time, so as to reduce the humidity in the machine by using the calorific value of the machine tool itself and prevent the electronic components from being affected with moisture. At the same time, it can also find out whether the battery alarm occurs in time to prevent the loss of system software parameters.